The Sixth Chapter Of The Stereoscopic Cutting Lesson: The Stereoscopic Cutting Of Skirt.

One

Stereoscopic cutting

Straight skirt is the most basic form of skirt.

(1) take out one piece of warp cloth, and the buttocks and the front centerline should be marked on the cloth.

(2) compound the cloth with the same name line.

(3) push the allowance to the princess line at the waist circumference and fix it with pins.

(4) make a shadow at the waist line and side seam, leaving a seam.

(5) the rear apron method is the same as the front apron.

Two

Stereoscopic cutting

The skirt of the wave skirt is larger, and the skirt is more body fitted, and the skirt forms waves in the longitudinal direction. Therefore, the fabric should be light and draped in the selection of fabric, and the 45 degree skew cut fabric should be used for the thick fabric.

(1) take a 45 degree skew cloth and mark the warp direction and hip line on the cloth.

(2) aligning the cloth with the same name line of the mannequin, and the 45 degree oblique cut fabric aligns the direction of the skew yarn with the front center.

(3) pull upward at the waist circumference, pull down at the corresponding hem, and cut the waist at the same time.

(4) after finishing the waves, trim the waistline and the hem and complete the skirt.

Three

Stereoscopic cutting

Pleated skirts include regular folds and free folds. Regular folds are mainly expressed as regular patterns of folds. Operation is relatively simple. Free folds are dominated by folds, and the expression of pleat is relatively abundant. The direction and starting point of pleat should be analyzed in operation to ensure that the effect of final pleat coincides with design intention.

In general, no matter what form it operates, its operation is basically the same, that is, first use the marking line to determine the location of the segmentation line and complete the segmentation.